Carrel Electrade - LP-1V3S Transducer


Home	Contact

Electrical Transducers

LP-1V3S data sheet.

LP-1V3S Single Element var Transducer

The LP-1V3S single element var transducer converts ac current and voltage signals into a dc output signal proportional to the reactive power flowing in the circuit.

The transducer is designed for 3 phase 3 wire systems with a balanced load.
The output of the transducer is unidirectional only.

Ordering information: LP-1V3S, inputs including CT & VT ratios, output, calibration, power supply.
Example: LP-1V3S, inputs 250/5A 110V, output 4-20mA, 0-50kvar, 110Vac supply

Basic Specifications:
Inputs	AC current and voltage, 3-phase 3 wire balanced load
	Current	: 0 - 1A or 0 - 5A (others on request)
	Voltage	: All ac system voltages to 440V
	Frequency	: 50Hz, 60Hz
Output	Load independent dc current and voltage
	(others on request)	: 0 - 10mA dc <1500Ω load
		: 0 - 20mA dc <750Ω load
		: 4 - 20mA dc <750Ω load
		: 0 - 5V dc >2kΩ load
		: 0 - 10V dc >2kΩ load
Accuracy		: Class 0.5 to IEC 60688
	Range	: 0 to 120% of nominal input
Power Supply		: 24V, 110V, 230/240V ac ±20%, 1.5VA
		: 24V or 110V dc ±20%, 2W
Isolation	Galvanic isolation between inputs, output circuit and auxiliary supply
	Test voltage	: 4kV 50Hz ac for 1 minute
Temperature	Operating	: 0°C to +23°C to +60°C
EMC Approvals		: AS/NZS 3548
		: C-Tick Mark approved

Dimensions

Carrel Electrade Limited
Proudly 100% New Zealand owned and operated.