Model T-ILA Surface Mount
T-ILA Loop Powered Current Transducer
The T-ILA current transducer converts an ac current input into a load independent 4 to 20mA dc signal capable of driving a number of independent instruments.
Accurate measurement assumes a sinusoidal input waveform.
The transducer has a built in ring type current transformer (CT).
The input is achieved by passing the current carrying conductor through the CT.
Standard input current ranges from 0-5A to 0-400A.
Two bore size options, 12mm for currents up to 200A & 18mm for currents up to 400A.
Available in DIN rail or surface mount enclosures.
Power for the unit is derived from the loop current.
Model T-ILA DIN Rail Mount
|Input||Sinusoidal alternating current|
|Standard ranges, others on request|
|12mm CT Bore||: 5A, 10A, 15A, 25A, 50A, 100A|
|18mm CT Bore||: 50A, 100A, 150A, 200A, 250A, 400A|
|Frequency||: 50Hz, 60Hz|
|Output||Load independent dc current|
|: 4 - 20mA dc <750Ω load|
|Accuracy||: Class 0.5 to IEC 60688|
|Range||: 0 to 120% of nominal input|
|Loop Supply||: 10 - 30V dc|
|Isolation||Galvanic isolation between input & output circuits|
|Test voltage||: 4kV 50Hz ac for 1 minute|
|Temperature||Operating||: -10°C to +20°C to +50°C|
|EMC Compliance||: AS/NZS 61000.6.3:2012|