Carrel Electrade - LP-2.5W4 Transducer


Home	Contact

Electrical Transducers

Data sheet

LP-2.5W4 Three Phase Watt Transducer
LP-2.5W4H Three Phase Watt Transducer with kWh Pulse Output

The LP-2.5W4 three phase Watt transducer converts ac current and voltage signals into a bi-directional dc output signal proportional to the active power flowing in the circuit.

The transducer is designed for 3 phase 4 wire systems
with an unbalanced load.
Optional output for scalable kW-hour pulses. (LP-2.5W4H)

Ordering information: LP-2.5W4, inputs including CT & VT ratios, output, calibration, power supply.
Example: LP-2.5W4, inputs 250/5A 400V, output 4-20mA, 0-200kW, 230Vac supply

Basic Specifications:
Inputs	AC current and voltage, 3-phase 4 wire unbalanced load
	Current	: 0 - 1A or 0 - 5A (others on request)
	Voltage	: All ac system voltages to 440V
	Frequency	: 50Hz, 60Hz
Output	Load independent bi-directional dc current and voltage
	(others on request)	: -10mA to 0 to 10mA dc <1500Ω load
		: -20mA to 0 to 20mA dc <750Ω load
		: 4 to 20mA dc <750Ω load
		: -5V to 0 to 5V dc >2kΩ load
		: -10V to 0 to 10V dc >2kΩ load
	Pulse	: Scalable kW-hour pulses
		: 2A, 110V, <10W dc (non-inductive)
Accuracy		: Class 0.5 to IEC 60688
	Range	: 0 to 120% of nominal input
Power Supply		: 24V, 110V, 230-240V, 400-415V ac ±20%, 1.5VA
		: 24V dc ±20% or 110V/125V dc (88V-138V), 2W
Isolation	Galvanic isolation between inputs, output circuits and supply
	Test voltage	: 4kV 50Hz ac for 1 minute
Temperature	Operating	: 0°C to +23°C to +60°C
EMC Compliance		: AS/NZS 61000.6.3:2012

Dimensions	LP-2.5W4	LP-2.5W4H

Carrel Electrade Limited
Proudly 100% New Zealand owned and operated.